Cub Cadet Collectors dot com

I too haven't been on here much, probably haven't posted in a couple years, but still have 5 Cub Cadets and use them as needed. Most of them are in good operating condition and I have learned most I needed to maintain or fix them already through this forum or the former registry, so don't have to as...

Here are a few drawings that someone posted on the old forum, sorry I don't remember who. I do remember some discussion that the hole in the cylinder rod end was smaller than the pin on the mount, so the parts drawn must be from two different versions. I think a few others have used an 8" stroke cyl...

Just a heads up to check the cylinder rod end pin hole and mount, the drawings show the front mount for the later, larger rod cylinder and the cylinder drawn is the earlier, smaller rod cylinder. The .531" hole in the cylinder rod needs a 1/2" pin, not 5/8". This was also mentioned on the old site. ...

I've added a dual spool valve to my 1650 and front and rear ports. The hydraulic angling works great as a time saver, and I have also been able to get out of slightly stuck situations by pushing the tractor back using the angling cylinder. As far as strength goes, my cylinder is the earlier setup wi...

Welcome Keith
Where in Canada are ya from?
Ryan

Hey everyone, sure is nice to see some resemblance of the registry, I gave up clicking the old bookmark a while ago. Thanks to those that got this going. I hope to get to AW's in a few weeks. I see Don from the far west Canada has checked in, and Army from up the road, any of the other Canucks check...