Reduction Drive Shaft Oil Seal
-
- Posts: 6
- Joined: Tue Jun 09, 2015 4:41 pm
- First and Last Name: Stacy Leis
- Location: Elroy, WI
Reduction Drive Shaft Oil Seal
Hi everyone could someone tell me how to get the Reduction Drive Shaft Oil Seal out without destroying anything ?thank you Stacy
- Attachments
-
- 20150830_100912.jpg (167.18 KiB) Viewed 1984 times
- Jlaws
- Posts: 1141
- Joined: Sun Sep 05, 2010 10:14 pm
- First and Last Name: Jess Laws
- Location: Independence , Ky
Re: Reduction Drive Shaft Oil Seal
Stacy , My usual method involves taking a sharp awl and punching two small holes on each side of the seal . Or you can also use a small drill bit and drill the holes . .
Then I take two sheet metal screws and thread them into the holes . I have two old screwdriver I use for pry bars that I put under the screw heads and pry on both sides , sometimes you have to alternate the pressure to walk them out . Most of the time they usually pop right out .
Then I take two sheet metal screws and thread them into the holes . I have two old screwdriver I use for pry bars that I put under the screw heads and pry on both sides , sometimes you have to alternate the pressure to walk them out . Most of the time they usually pop right out .
I see a lot of cub cadets while going down the tracks , its a shame I can't pull over and ask about them .
-
- Posts: 6
- Joined: Tue Jun 09, 2015 4:41 pm
- First and Last Name: Stacy Leis
- Location: Elroy, WI
Re: Reduction Drive Shaft Oil Seal
thank you we got it out