I ordered a new fan for the 149 as there was only one blade left. What is the proceedure for replacing it?
Lance
149 Hydro cooling fan replacement
- Farmallgray
- Posts: 1021
- Joined: Mon Sep 06, 2010 7:39 am
- First and Last Name: Todd Markle
- Location: Spring Mills, Pa
Re: 149 Hydro cooling fan replacement
You will have to remove either the engine or the transaxle to get the driveshaft out. Engine might be easier since you wont have to disturb the hydro linkage. It is a fairly involved job. I believe we have the service manual somewhere on this site that you can download. It would help to read over the procedure in there first.
See my IH, Cub Cadet and tractor pulling youtube videos;
http://www.youtube.com/user/farmallgray
http://www.youtube.com/user/farmallgray
-
- Posts: 2
- Joined: Fri Jan 25, 2013 8:18 pm
- First and Last Name: Patrick OBrien
- Location: Sequim
Re: 149 Hydro cooling fan replacement
old149Lance wrote:I ordered a new fan for the 149 as there was only one blade left. What is the proceedure for replacing it?
Lance
unbolt the 4 bolts on the flex joint next to the pump end of drive go to engine end of drive shaft drive out role pin take small pri parpry forward tap apart easy
-
- Posts: 180
- Joined: Wed Nov 07, 2012 12:27 am
- First and Last Name: George Riley
- Location: Poverty Springs KY 2018 Wettest State in the Nation
Re: 149 Hydro cooling fan replacement
How vital is this fan ??
The one on my 129 is down to one brittle blade.
Thanks for the dis-assembly instructions, as I will be referring to them when I get a new fan.
Thanks.
The one on my 129 is down to one brittle blade.
Thanks for the dis-assembly instructions, as I will be referring to them when I get a new fan.
Thanks.
-
- Posts: 64
- Joined: Thu Feb 10, 2011 12:48 pm
- First and Last Name: Lance Trgina
- Location: Wakefield, VA
Re: 149 Hydro cooling fan replacement
Finally got time to install new fan. It took longer to knock the pin out of the front of driveshaft than anything else. Heat and PB helped. Will have to get the cup assembly and new pin as mine is kind of wallowed out but not too bad. Will replace rag joint also at that time. Lance