Gents,
I've had the tractor running for awhile, but I finally have some time to get some good maintenance going on it. Through the serial number crosswalk I've determined that it was built in NOV 1962. Most of the belts need replacing and I'm struggling to identify my mower deck through the manuals on the website. I believe that this is the Rotary Mower (38-inch) that does not have a PTO. However, when I get into the belt guide that terminology doesn't quite transfer directly.
Can someone help confirm that these are the belts I would need:
745-0226 PTO
IH-464860-R2 Timing
IH-464351-R1 Spindle
IH-376230-R1 Clutch
IH-376230-R1 Starter/Generator
Thank you in advance,
Jack
1962 Original Cub Belt Help
-
- Posts: 4
- Joined: Fri May 03, 2013 12:23 pm
- First and Last Name: Jack Johannes
- Location: Memphis, TN
1962 Original Cub Belt Help
- Attachments
-
- IMG_20140711_083105_725.jpg (1.02 MiB) Viewed 3067 times
-
- IMG_20140711_083116_876.jpg (1.08 MiB) Viewed 3067 times
-
- IMG_20140711_083125_813.jpg (1.04 MiB) Viewed 3067 times
- cjrolke
- Posts: 91
- Joined: Sun Apr 03, 2011 8:37 pm
- First and Last Name: Chris Rolke
- Location: Loveland, OH
Re: 1962 Original Cub Belt Help
here is the link I used
ORIGINAL GEN IH-376230-R1 - 3/8 X 31 1/2"
CLUTCH IH-376230-R1- 3/8 X 31 1/2"
38" 2 BLADES 954-0226- 1/2 X 82" 38" IH-464351-R1 -1/2 X 30"
Timed Deck Belt IH-464860-R2
http://cubfaq.com/belts.html
ORIGINAL GEN IH-376230-R1 - 3/8 X 31 1/2"
CLUTCH IH-376230-R1- 3/8 X 31 1/2"
38" 2 BLADES 954-0226- 1/2 X 82" 38" IH-464351-R1 -1/2 X 30"
Timed Deck Belt IH-464860-R2
http://cubfaq.com/belts.html
-
- Posts: 4
- Joined: Fri May 03, 2013 12:23 pm
- First and Last Name: Jack Johannes
- Location: Memphis, TN
Re: 1962 Original Cub Belt Help
Chris,
So you have the same mower set up that I have?
So you have the same mower set up that I have?
- cjrolke
- Posts: 91
- Joined: Sun Apr 03, 2011 8:37 pm
- First and Last Name: Chris Rolke
- Location: Loveland, OH
Re: 1962 Original Cub Belt Help
yep
when you change the timed belt make sure you have the blades positioned correctly otherwise they will hit each other
it does a nice job
when you change the timed belt make sure you have the blades positioned correctly otherwise they will hit each other
it does a nice job