Installing VR in 128
Installing VR in 128
Here is a picture of the VR that I took after cutting the bolts that hold it to the opposite side of the mounting bolts where it was ground off.
These are pictures of the rear fenders removed and seat removed and old and new VR
which has to attach to the holes which can only be seen turned on side and shown better on the side where the bolts where ground off.
anyideas how I can do this?- tc429
- Posts: 69
- Joined: Sun Dec 02, 2012 11:45 pm
- First and Last Name: Tim C
- Location: Barberton, OH
Re: Installing VR in 128
what are you trying to do? if wanting to attach from one side, self tapping screws, or riv-nuts would be best, be sure to use a star washer on at least one bolt to help ensure a good ground...sorry if I'm misunderstanding the "anyideas how I can do this?" question...
-
- Moderator
- Posts: 1175
- Joined: Tue Sep 07, 2010 6:22 pm
- First and Last Name: Joe Motuzick
- Location: Torrington Ct
Re: Installing VR in 128
Geezer
There is room to reach in behind the tire and install the V/R the battery needs to be out and you need to be "praying" to the back of the tractor.
There is room to reach in behind the tire and install the V/R the battery needs to be out and you need to be "praying" to the back of the tractor.