looking for a source

This is just like the old coffee shop, which was like the old coffee shop down the street. Pull up a chair, sit down and enjoy some good discussions. Please, no political, religious or racial posts.
Post Reply
madmolly3
Posts: 74
Joined: Wed Feb 16, 2011 2:50 pm
First and Last Name: Michael Mollohan
Location: lincoln, Illinois

looking for a source

Post by madmolly3 »

I'm looking for a special crimping tool to put angles on end of choke cable. Friend had a set and can not find. Thanks in advance Mike

User avatar
SWilliams
Posts: 805
Joined: Mon Sep 06, 2010 7:14 pm
First and Last Name: Steve Williams
Location: Fort Plain NY (Upstate NY near Cooperstown)

Re: looking for a source

Post by SWilliams »

Owner of an 1863, 2263 (1863 W 22hp engine!) 2084 and a 2 - 2284s.


"In God we trust, All others pay CASH..."

User avatar
mmzullo
Posts: 365
Joined: Mon Sep 06, 2010 5:18 pm
First and Last Name: Mike Marzullo
Location: Kinnelon,NJ

Re: looking for a source

Post by mmzullo »


User avatar
Farmallgray
Posts: 1021
Joined: Mon Sep 06, 2010 7:39 am
First and Last Name: Todd Markle
Location: Spring Mills, Pa

Re: looking for a source

Post by Farmallgray »

I like that pliers idea! I have done it many times using two pairs of pliers. I tried one of the tools like Mike posted, but I
wasn't impressed with how it worked and went back to using pliers.
See my IH, Cub Cadet and tractor pulling youtube videos;
http://www.youtube.com/user/farmallgray

madmolly3
Posts: 74
Joined: Wed Feb 16, 2011 2:50 pm
First and Last Name: Michael Mollohan
Location: lincoln, Illinois

Re: looking for a source

Post by madmolly3 »

did some practice bends on extra cable, after about two tries....pliers wrked great. thanks for the input

Post Reply