Need measurements for 190-413 weight bracket

[jaktomas]

I am looking for the basic measurements (length and width) in order to make a Weight Bracket 190-413 for my 3186.
Thanks for your help.

[stevet]

I have one at home, I will get the measurements for you this afternoon....

[jaktomas]

I have one at home, I will get the measurements for you this afternoon....

Thanks so much, they want $100 for a new one, I am sure I can make one for less,

[stevet]

0202161640-1.jpg (1.01 MiB) Viewed 3317 times

Ok, here you go. There are 2 widths...between the nuts that are welded on is 13 1/2 in, the overall width is 14 5/8 in. If I'm not mistaken it slides into the frame rail and is bolted from the outside. The overall length is 15 1/2 in. The height where it slides into the frame rail is 2 3/8, and 4 in total where the weights hang. Confused yet? Lol. I would have done the measurements in the pic on my computer but I'm having internet issues...

[jaktomas]

0202161640-1.jpg

Ok, here you go. There are 2 widths...between the nuts that are welded on is 13 1/2 in, the overall width is 14 5/8 in. If I'm not mistaken it slides into the frame rail and is bolted from the outside. The overall length is 15 1/2 in. The height where it slides into the frame rail is 2 3/8, and 4 in total where the weights hang. Confused yet? Lol. I would have done the measurements in the pic on my computer but I'm having internet issues...

Stevet--
Thanks for the quick reply.
Your information is perfect for my project.
You don't sound like you use yours, would you like to sell it?
If you do please Email me.

[stevet]

I actually will wind up using it in the spring once the snowblower is off. Just an fyi, it should work on the front or back of the tractor...