Cub Cadet Collectors dot com

hi the seals on my transmission is leaking on the back and the left side can these seals be replaced if so best place to get parts how do i know what model pump i have is there a manual and yes lot of ?? lol thank you very much

Ronnie...All Cub parts r looked up using the tractor model. Use a store or online Cub store. Two good ones to find parts r.... Cubcadetpartsnmore.com or partstree.com . They all kinda use a similar style look up. U will start with your brand, then garden tractor, then 1811, then hydrostatic transmission, at that point u will see a blow up of your trans and u can write down part numbers or add to Cart.
Both those seals should b replaceable for pretty cheap.
Keep us posted on your progress

how do i know what pump is in this tractor is there a tear down manual

Only one trans. There apparently is a document and manual section right here on this very website. Up top in the tool bar. I haven't been there but it might have what u need.

I just looked in the manual section....Under 82 series service manual there is a pic of the exploded trans.....But that's it. They won't tell u how to replace seals. Go to utube for that. The hard part about the job u want to do is getting them out without damaging the surroundings. Small pics ...Screws ...And a drill will probably b in order.

so i assume nobodys has done this theres nothing on utube on what im looking for i found some on a jd but nothing on what im looking for im looking for more on the seals 4.5 6 both sides and the one on the back ive checked this site and others searched the net so i have been looking thanks

Ronnie..i would not assume anything....guys hear do seals all the time and those you r talking about get done but not as much as some others. What exactly r u looking to do....rebuild the trans or just a few seals. If its the seals....i dont really think u need a manual for that. Most service manuals will say..."install seal". They might talk about the depth of it if it different from flush....or they might say to use seal driver kh867-5309. Good luck and keep us posted

i would like to hear how they did it was there things to look for theres roll pins in there how did they get them out i like as much info as i can when taking things apart that i havent done knowlege is a good thing and i really want more info manuals are not always right on so information is a good thing so i dont think im asking to much sorry if im a bother

Ronnie,
Manual is here...

http://service.mtdproducts.com/Training ... -3899.html