Page 1 of 1
2082 no start after 18 hp engine swap
Posted: Mon May 14, 2018 3:08 pm
by kbrothers
PTO went out on my 2082 and starter has acted up since I changed it so I decided to pull the motor out of my 1882 mower that the hydro went out on last year. Got the swap finished today but it won't run. I did notice the 2082 engine had an extra wire on the positive starter post which the 1882 didn't all help and info appreciated greatly TIA Ken in PA
Re: 2082 no start after 18 hp engine swap
Posted: Mon May 14, 2018 7:42 pm
by SWilliams
Here are the wiring diagrams for both.
- 1882.pdf
- (1.79 MiB) Downloaded 213 times
- 2082.pdf
- (1.02 MiB) Downloaded 207 times
Re: 2082 no start after 18 hp engine swap
Posted: Tue May 15, 2018 6:29 am
by kbrothers
Thanks,Steve I think maybe the problem is the 1882 engine is out of a low serial # 314469 tractor? All info I find is for 800000 and up Thanks again
Re: 2082 no start after 18 hp engine swap
Posted: Tue May 15, 2018 10:18 am
by JMotuzick
314xxx would make it a Narrow Frame. I’m guessing the s/n is 814xxx. With out looking at the schematic they should have the same wiring....
Re: 2082 no start after 18 hp engine swap
Posted: Tue May 15, 2018 11:23 am
by l palma
When you say no start, does it turn over or not?
Both tractors use the same harness, according to this wiring diagram, so here is what I have for you.
Re: 2082 no start after 18 hp engine swap
Posted: Sun May 27, 2018 5:07 pm
by kbrothers
Thanks Lewis Got it running it was a carb issue from setting Then had a pulley issue. Tomorrow I have to find out where the hydro is leaking from-oil all over the floor after mowing and setting overnight