clutch questions

This is your place for high horsepower and traction!

clutch questions

Postby bbungard » Thu May 17, 2012 10:25 am

Getting ready to build a puller and was wondering about the clutch.....i no in my pulling truck the clutch needs to be the best of best.....and it broke tthe bank for a clutch....i was looking at mwsc clutchs and they have everything from replacement to radical i need a 6 pin driver? What about the clutch disc....i like the ones that are rebuildable but do i need something that serious? And what about the arms? Should i just get the kit?
Beat it like it owes you money$$
Posts: 44
Joined: Sat Jan 01, 2011 6:48 pm
City and State: Waynesburg ohio
First and Last Name: Brandon C Bungard

Re: clutch questions

Postby Farmallgray » Thu May 17, 2012 4:13 pm

What class are you running? It depends on that and how handy you are at fabricating. If you are running the stock classs,
a double disc setup based on stock parts will work fine. Brian Miller's site shows how they are made and you should be able to do most of the work yourself for next to nothing. A 6 pin driver is a good idea because it spreads the load over twice as many pins.
The double clutch diagram is near the bottom of the page.
See my IH, Cub Cadet and tractor pulling youtube videos;
User avatar
Posts: 1021
Joined: Mon Sep 06, 2010 7:39 am
City and State: Spring Mills, Pa
First and Last Name: Todd Markle

Re: clutch questions

Postby jroy » Fri May 25, 2012 10:47 am

I run a single disc with a three pin driver in my 14hp 1150lb class tractor. The only upgrade I did was adding a red spring.
Last edited by jroy on Tue Jun 12, 2012 10:42 am, edited 1 time in total.
Posts: 4
Joined: Mon Oct 03, 2011 1:13 pm
City and State: Colchester, CT
First and Last Name: Josh Roy

Re: clutch questions

Postby Supernational » Mon Jun 11, 2012 12:19 pm

i run a 6 puck driver along with hardened drive shaft and billet pressure plates and a red spring
Posts: 2
Joined: Fri Jun 08, 2012 9:46 pm
City and State: Camden, OH
First and Last Name: Wyatt Downard

Return to Pullers

Who is online

Users browsing this forum: No registered users and 0 guests