Post your custom tools or how to information here (caption your photo's) and we'll move any that are good to archive, into the How To section of the manuals.
Forum rules
This section is reserved for semi detailed posts describing how you made a custom tool, or a detailed procedure for repairing a certain assembly of a tractor. Pictures are pretty much required
Posts in this section now have to be approved before they become visible.
If your looking for help repairing something please post in the shooting the breeze or the forum that pertains to your question.
I have 128 with a tiller, I could not lift tiller with one hand so I bought a 2000 lb. winch from Harbor Freight for $50, and mounted on the front of tractor, used a short piece of angle iron on where the mower deck would have attached for different angle. I ran the winch cable thru a pulley on the end of this angle iron to where the mower deck mounted in front and secured it there. now the winch has an easier pull, plus does not lift as fast as direct.
This sure sounds like a fun way of lifting . I would be careful though, there r roll pins in the rockshaft u r lifting on that could snap if u r not very light on the trigger. I think cub had a spring assist for that as well. I would like to get a helper spring for my 127. Dave
127, 1650, 1572, 1872, 2072 . A mower, blower and blade for each.
The winch comes with a rocker switch on extension wire for in and out. I put a hose clamp on lock button on lift handle so latch is disengaged.
I put a piece of tape on the cable so I know when tiller is almost full lift just before tape gets to roller.
"A lazy man carries a sharp knife".